Safety Instructions - ALLEN & HEATH ZED 420 User Manual

WARNINGS
Read instructions:
Do not remove cover:
Power sources:
Power cord routing:
Grounding:
!
Water and moisture:
Ventilation:
Heat and vibration:
Servicing:
Installation:
Allen & Heath

SAFETY INSTRUCTIONS

-
Read the following before proceeding :
ATTENTION: RISQUE DE CHOC ELECTRIQUE – NE PAS OUVRIR
Retain these safety and operating instructions for future reference. Adhere to all warnings printed here
and on the console. Follow the operating instructions printed in this User Guide.
Operate the console with its covers correctly fitted.
Connect the console to a mains power unit only of the type described in this User Guide and marked
on the rear panel. Use the power cord with sealed mains plug appropriate for your local mains sup-
ply as provided with the console. If the provided plug does not fit into your outlet consult your service
agent for assistance.
Route the power cord so that it is not likely to be walked on, stretched or pinched by items placed
upon or against it.
Do not defeat the grounding and polarisation means of the power cord plug. Do not remove or tam-
per with the ground connection in the power cord.
WARNING: This equipment must be earthed.
To reduce the risk of fire or electric shock do not expose the console to rain or moisture or use it in
damp or wet conditions. Do not place containers of liquids on it which might spill into any openings.
Do not obstruct the ventilation slots or position the console where the air flow required for ventilation
is impeded. If the console is to be operated in a rack unit or flightcase ensure that it is constructed to
allow adequate ventilation.
Do not locate the console in a place subject to excessive heat or direct sunlight as this could be a fire
hazard. Locate the console away from any equipment which produces heat or causes excessive vi-
bration.
Switch off the equipment and unplug the power cord immediately if it is exposed to moisture, spilled
liquid, objects fallen into the openings, the power cord or plug become damaged, during lightening
storms, or if smoke, odour or noise is noticed. Refer servicing to qualified technical personnel only.
Install the console in accordance with the instructions printed in this User Guide. Do not connect the
output of power amplifiers directly to the console. Use audio connectors and plugs only for their
intended purpose.
CAUTION
5 ZED-4 BUS User Guide