GE GSHS6KGZCCSS Owner's Manual And Installation page 9

About the shelves and bins. G App ancesc
Not all features are on all models.
Z__ _ _, QuickSpace
TM
Shelf (on some models)
This shelf splits in half and slides under itself for
storage of tall items on the shelf below.
This shelf can be removed and replaced or
.zJ relocated just like Slide-OutSpillproof Shelves.
On some models,this shelf can not be used in
the lowest position.
Slide-Out Freezer Shelves
Toremove, slide out to the stop position, lift the
front past the stop position, and slide out from
rib.
Hake sure you push the shelves all the way
back in before you close the door.
Fixed Freezer Shelves
To remove, lift the shelf up at the left side and
then bring the shelf out.
Door Wine/Beverage Rack
(on some models)
This rack holds up to 5 cans, one bottle of
wine or one 2-liter bottle of soda.
The rack hangs from the sides of the dairy bin.
To remove:
O Empty the wine/beverage rack.
O Holding the bottom of the dairy bin, lift the
front straight up, then lift up and out.
O To detach the rack from the dairy bin, pull
the rack's side wires out of the holes on
each side of the dairy bin.
NOTEFORDISPENSER MODELS:In order to
take full advantage of the tilt-out ice bin (on
some models),only store items on the shelf
below the ice bin that are no taller than the
lowest point on the bin.
To replace:
Reattach the rack to the sides of the bin.
Engage the back side of the bin in the
molded supports on the door. Then push
down on the front of the bin.The bin will
lock into place.
ShelfSaverT. Rack
(on some models)
Use this rack to store
beverage cans for easy
access,
It can also hold a 9" x 15"
baking dish.
Door Can Rack
(on some modelsl
This door rack holds up to 9 cans.
NOTE:This rock can only be
mounted in the top position under
the dairy bin.
Removable Beverage
Rack
(on some modelsl
The beverage rack is designed to
hold a bottle on its side. It can be
attached to any slide-out shelf.
To install:
Line up the large part of the
slots on the top of the rack with
the tabs under the shelf.
Then slide the rack back to lock
_tin place.