Makita 2702X1 Instruction Manual page 20

Spindle
CUT
WIDTH
•
1/8"
•
1/4"
•
5/16"
•
3/8"
•
7/16"
•
1/2"
20
Table insert
(Part No. 317061-6)
When cutting grooves 5/16", 3/8",7/16" or 1/2" use this
table insert instead of the standard table insert.
To install the dado head set, proceed as follows:
1. Turn the tool off and unplug it before installing.
2. Remove the blade guard with the spreader.
3. Install the dado head set with the teeth pointing down
at the front of the table.
4. Use the chart below to select the proper cutters to
obtain the various cutting widths.
Outside
Inner
Ring
Cutter
flange
• •
• •
• •
• •
• •
• •
CAUTION:
• For a 1/8" cut width, the outside cutter is assembled to
the spindle in the same manner as the saw blade.
• The outer flange or the dado outer flange must be
used for each cut width.
• The hex nut alone must not be used to secure the
dado on to the spindle.
1/8" 1/16"
Outside
Inside Inside
cutter
cutter cutter
•
• •
• •
• • •
•
•
x 2
Dado
Outer
Washer
Outer
flange
flange
•
• •
• •
• •
•
•
Dado
Hex
Hex
nut
nut
•
•
•
•
•
•