Makita 2702X1 Instruction Manual page 19

ACCESSORIES
1/8" 1/8" 1/16"
CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments
might present a risk of injury to persons.
Only use accessory or attachment for its stated pur-
pose.
Dado head set
A dado is cutting a rabbet or a wide groove into the
workpiece. The dado head set consists of two outside
cutters, three inside cutters and paper washers.
Outside cutters: 6"diameter, 1/8" thick, 5/8"arbor hole, 2 pcs.
1/8" 1/8"
Inside cutters: 6"diameter, 1/8"thick, 5/8"arbor hole, 2 pcs.
Inside cutter:
Paper washers:
Various combinations of these cutters are used to cut
grooves from 1/8" to 1/2" for use in making joints,
tenoning, grooving, etc.
Dado flange set
1. Dado outer flange
1
When cutting groove 1/4", 5/16", 3/8", 7/16" or 1/2" ,
use this dado outer flange.
2. Dado hex nut
When cutting groove 1/4", 5/16", 3/8", 7/16" or 1/2" ,
2
use this dado hex nut.
3. Ring
When cutting groove 1/4", 5/16", 3/8", 7/16" or 1/2" ,
use this ring.
3
4. Washer
When cutting groove 1/4", 5/16" or 3/8", use this
washer.
4
(Part No. 191543-4)
6"diameter, 1/16"thick, 5/8"arbor hole, 1 pc.
(Part No. 192693-8)
5/8"arbor hole, 6 pcs.
19