Makita 2702X1 Instruction Manual page 17

1. Push stick
1. Auxiliary fence
1. Push block
2. Auxiliary fence
3. Turn the tool on and gently feed the workpiece into
the blade along with the rip fence.
(1) When the width of rip is 150 mm (6") and wider,
(2) When the width of rip is 65 mm - 150 mm (2-1/2"
1
(3) When the width of rip is narrower than 65 mm
1
Feed the workpiece by hand until the end is about
1
25 mm (1") from the front edge of the table. Continue
to feed using the push block on the top of the auxiliary
fence until the cut is complete.
2
carefully use your right hand to feed the work-
piece. Use your left hand to hold the workpiece
in position against the rip fence.
- 6") wide, use the push stick to feed the work-
piece.
(2-1/2"), the push stick cannot be used because
the push stick will strike the blade guard. Use the
auxiliary fence and push block.
Attach the auxiliary fence to the rip fence with
two "C" clamps.
17