Access To Terminal Block & Grounding Strap; Electrical Connection To The Range - Kenmore 79042603311 Installation Instructions Manual

| Access to Terminal Block &
Grounding Strap (U.S.A.)
Electrical Connection to the
Range (U.S.A.)
This appliance is manufactured with the neutral
terminal connected to the frame,
Remove the wire cover here
for access to terminal block
Figure 5
This appliance is manufactured with
the frame grounded by connection of a grounding
strap between the neutral power supply terminal and
the frame. If used in USA, in a new branch circuit
installation (1996 NEC), mobile home or recreational
vehicule, where local code do not permit grounding
through neutral (white) wire or in Canada; remove the
grounding strap from the frame and cut the other end,
near the neutral terminal. Connect the appliance in
usual manner.
Three Conductor Wire Connection to Range
if local codes permit connection of the frame
grounding conductor to the neutral wire of the
copper power supply cord (see Figure 6):
1. Remove the screw which is fixing the rear wire cover,
then remove the rear wire cover (access cover) to
expose range terminal connection block (see Figure
5).
2. Using the nuts supplied in the literature package,
connect the neutral of the copper power supply cord
to the center silver-colored terminal of the terminal
block, and connect the other wires to the outer
terminals. Match wires and terminals by color (red
wires connected to the right terminal, black wires
connected to the left terminal) (see figure 6).
3.Put back the rear wire cover using the screw
removed on step 1.
Grounding Silver Colored Terminal
Strap
Red Wire
Terminal
Block
Electrical Shock Hazard
• Electrical ground is required on this appliance.
• Do not connect to the electrical supply until
appliance is permanently grounded.
• Disconnect power to the circuit breaker or fuse
box before making the electrical connection.
• This appliance must be connected to a
grounded, metallic, permanent wiring system,
or a grounding connector should be connected
to the grounding terminal or wire lead on the
appliance.
Failure to do any of the above could result in a
fire, personal injury or electrical shock.
Black
Wire
A User Supplied
Strain-relief Must
Be Installed at
This Location.
To 240 V Receptacle
Figure 6
1 1/8" (2,9 cm) Dia.
Direct Connection
Hole. Punch Out
Knockout for 1 3/8"
(3,5 cm) Dia. Cord
Kit Hole.