Advertisement
LOCATION OF YOUR WASHER
DO NOT INSTALL YOUR WASHER:
1,
In an area exposed to dripping water or outside
weather conditions, The ambient temperature
should never be below 60 degrees
F (15,6
degrees C) for proper washer operation,
2,
In an area where it will come in contact with
curtains or drapes,
3,
In an area (garage or garage-type
building)
where gasoline of other flammables are kept
or stored (including automobiles),
4,
On carpet,
Floor
MUST
be solid
with
a
maximum slope of 1/2 in. per foot (1,27 cm
per 30.5 cm), To ensure vibration or movement
does not occur, reinforcement of the floor may
be necessary.
IMPORTANT
MINIMUM INSTALLATION CLEARANCES
When installed in alcove: Sides, Rear, Top = 0 in
(0 cm).
When installed in closet: Sides, Rear, Top = 0 in
(0 cm), Front = 1 in (2.54 cm),
Closet door ventilation openings required: 2 louvers
each 60 in 2 (387 cmz) - 3 in (7.6 cm) from top and
bottom of door,
UNPACKING
1,
Cut the shipping carton along the dotted line
along the base of the unit.
2,
While in the carton carefully lay the washer
on its back side,
3,
Remove the styrofoam base.
4,
Carefully
return the washer
to an upright
position and remove the carton.
5,
Carefully move the washer to within 4 feet
(122cm) of the final location.
6,
Remove the following
from the back side of
the washer:
3 bolts,
3 yellow plastic spacers,
7, Remove the service panel from the front of the
washer.
8, Remove the 4 nuts and 6 large washers that
attach the 2 yellow shipping braces to the drum
and the base, Lift up on the drum and remove
the braces (a yellow ribbon surrounds the items
to be removed). These braces must be removed
to allow the power supply cord to be released
from the shipping ring,
9, Remove the large styrofoam block located under
the drum. Lift up on the drum, tilt the base of
the foam block inwards toward
the rear of the
washer until free, then pull it out.
10. Remove and discard the yellow ribbon and label
from the front of the washer.
\
\
®
@
11. From the rear of the washer, carefully pull out
the power supply cord through the hole in the
backsheet.
12. Replace the service panel and screws.
NOTE: If the washer is to be transported at a
later
date, the shipping support
hardware must be reinstalled to prevent
shipping damage.
BOLT
SPACER
(_)
'P!' CLAMP
6
Advertisement
