Electrolux EW27EW65PSB Use And Care Manual page 36

36 Setting Oven Controls
Setting Fresh Clean
Do not leave small children unattended near the appliance.
During the fresh clean cycle, the outside of the oven can become
very hot to touch and can cause burns.
Do not force the oven door open when fresh clean is active. This
can damage the automatic door-locking system. Use caution
when opening the door after fresh cleaning. The oven may still
be very hot and can cause burns. To avoid possible burns, stand
to one side of the oven when opening the oven door to allow hot
air or steam to escape. The fresh clean feature will not operate
if the lower or upper oven is on.
IMPORTANT! The kitchen area should be welt ventilated. Use
an open window, ventilation fan, or exhaust hood during the first
fresh clean cycle to help eliminate the normal odors associated
the initial clean cycle.
To start a fresh clean:
1. Ensure the oven is empty and remove all oven racks and
racks support. Be sure the clock is set with the correct
time of day and the oven door is completely closed.
2.
3.
4.
Select an oven by pressing either UPPER
OVEN or LOWER OVEN to light up the
available cooking modes keys.
Press fresh clean. REMOVE RACKS will
appear in the display and blink. And the
oven will chime.
The fresh clean feature allows you to
choose one of three time options. Press
lite for a 2-hour clean (Figure 34); or
UPPER OVEN
LOWER
OVEN
fresh
dean
lite
21 rl ri
DrL, -, ,:..,.
Figure 34:2 hour lite clean
5. Press med (normal) for a 3-hour clean
(Figure 35); or
0o
meal
REMOVE RACKS wilt flash in the display for several seconds
as a reminder to remove the racks before starting a fresh clean
cycle.
Figure 37: Remove racks indicator
7. Press START enter to begin cleaning.
4>
START
enter
Once active, the door lock motor will begin locking the oven
door. DOOR wilt blink in the display.
• Do not try to open the door when the DOOR message is
blinking or once it is on (allow about 15 seconds for the
oven door to completely lock).
• Once the oven door is locked the CLn message wilt appear
in the display for the entire fresh clean cycle (Figure 36).
When the fresh clean cycle is finished:
Use caution when opening the oven door after fresh cleaning.
The oven may still be very hot and can cause burns. To avoid
possible burns, stand to the side of the oven when opening the
oven door to allow hot air or steam to escape. The oven bake
and broil elements may appear to have cooled after they have
been turned off. The elements may still be hot, and burns may
occur if these elements are touched before they have cooled.
1. The time of day and Hot will show in the display
(Figure 38).
2. Once the oven has cooled (about 1 hour) and Hot is no lon-
ger displayed, the door lock message wilt flash. When this
message stops flashing in the display, the door has finished
unlocking and may be opened.
Figure 38: Hot oven (door still locked)
"_1 r!
r:i
D,rL, -, -,.,.
Figure 35:3 Hour normal clean
6. Press heavy for a 4-hour clean (Figure 36).
Figure 36:
D m mR _1_
, I rl rl
LL I-'
-i'UU
4 Hour heavy clean
oo®
heavy
The oven bake and broil elements may appear to have cooled
after they have been turned off. The elements may still be hot
and burns may occur if these elements are touched before they
have cooled.
3. After the oven has cooled, wipe away any residue or pow-
dered ash from the oven interior using a damp cloth or
paper towel.
G3
A fresh clean cycle wilt not start if the control lock feature is
active. If a fresh clean cycle was started but did not finish due to
a power outage, your oven may not have completely cleaned.