Subscribe to Our Youtube Channel
Related Manuals for Muskoka MFB28-2
Summary of Contents for Muskoka MFB28-2
-
Page 1: Instructions For Use
MODEL NO. MFB28-2 INSTRUCTIONS FOR USE Natural flame effect Constant temperature Ventilator control switch Energy-saving Easy to use Elegant design Plug connected 120V~ 60Hz 1400W 第 1 页... -
Page 2: Important Instructions
IMPORTANT INSTRUCTIONS 1. Read all instructions before using this heater. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least three feet (0.9m) from the front of the heater and keep them away from the sides and rear. -
Page 3: Manual Controls
and cause a risk of fire. 16. This heater may include an audible (a visual) alarm to warm that parts of the heater are getting excessively hot, if the alarm sounds (flashes), immediately turn the heater off and inspect for any objects on or adjacent to the heater that may cause high temperatures. - Page 4 Unpacking and installing the appliance Open the packaging carefully and remove the appliance. Keep the original packaging for future transport. Keep the front of the appliance through which the heat is radiated at least one meter away from furniture, curtains and other flammable objects at all times. Ensure there is a grounded socket nearby.
- Page 5 cannot be used for any other purpose. Any damage due to inappropriate operation, wrongful use or not observing the safety instructions is not covered by the guarantee. Please operate the heater after inserting it into the mantle. Never operate the appliance when the appliance itself or the mains cable show any signs of damage.
- Page 6 Instructions for the approved electrotechnician The appliance comes with the following light bulbs: two 40W light bulbs(max. 40W) Changing the bulbs Warning: unplug first! The plug must be removed from the socket-outlet before changing 1. open the front access panel 2.
- Page 7 3. change the bulbs CAUTION: sharp edges! You can now replace faulty bulbs by identical ones with the same wattage. For assembly, proceed in reverse order. 1. After installation, the power plug should be accessible. 2. if the power cord is damaged. It must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
-
Page 8: Electrical Diagram
Grounding instructions This heater is for use on 120 volts. The cord has a plug as shown in Figure A. Figure A Technical data: Mains voltage: 120V Mains frequency: 60Hz Nominal charge: max. 1400W ELECTRICAL DIAGRAM 第 8 页... - Page 9 第 9 页...
Need help?
Do you have a question about the MFB28-2 and is the answer not in the manual?
Questions and answers