Cleaning The Door And Drawer - GE P2B940DEH1WW Owner's Manual

Cleaning The Door and Drawer
To clean the inside of the door
Do not allow excess water to run into any holes or slots
in the door.
Wipe dishwashing detergent over any baked-on spatters
on the glass. Use a single sided safety razor blade to
clean it off. Then wipe over the glass with a soapy cloth
to remove any residue and dry off.
The area outside the gasket can be cleaned with a
soap-filled plastic scouring pad.
The gasket is designed with a gap at the bottom to
allow for proper air circulation.
Do not rub or clean the door gasket-it has an
extremely low resistance to abrasion,
If you notice the gasket becoming worn, frayed or
damaged in any way or if it has become displaced on
the door, you should have it replaced,
Removable Drawer (Warming Drawer Models only)
NOTE: For models with an electric warming drawer,
before performing any adjustments, cleaning or service,
disconnect the range electrical power supply at the
household distribution panel by removing the fuse or
switching off the circuit breaker. Make sure the warming
drawer heating element is cool.
Most cleaning can be done with the drawer in place.
However, the drawer may be removed if further cleaning
is needed. Use soap and warm water to thoroughly
clean.
To remove the drawer:
1. Pull drawer straight out
until it stops,
2. Press the left rail release
up and press the right
rail release down, while
pulling the drawer
forward and free,
To replace the drawer:
1. Place the left drawer rail around the inner left rail guide
and slide it in slightly to hook it,
2. Place the right drawer rail around the inner right rail
guide and slide it in slightly to hook it,
3. Slide the drawer all the way in,
Cb
:1:=,
Z
qb
r-Pi
Z
Z
©
I I
Cb
I
(T)
I i
LC3
:3-
©
0
0
C_
CZ
C2
©
49 852124
27