Makita 3621 Instruction Manual page 10

A
1
1. Screw
2. Base plate
3. Templet guide
1
3
4
5
1. Bit
2. Templet guide
3. Base
4. Templet
5. Workpiece
10
When cutting, move the tool with the straight guide flush with
003261
the side of the workpiece. If the distance (A) between the
side of the workpiece and the cutting position is too wide for
the straight guide, or if the side of the workpiece is not
straight, the straight guide cannot be used. In this case,
firmly clamp a straight board to the workpiece and use it as a
guide against the router base. Feed the tool in the direction
of the arrow.
Templet guide (optional accessory)
003262
The templet guide provides a sleeve through which the bit
passes, allowing use of the router with templet patterns.
To install the templet guide, loosen the screws on the tool
003263
2
base, insert the templet guide and then tighten the screws.
3
Secure the templet to the workpiece. Place the tool on the
003264
templet and move the tool with the templet guide sliding
2
along the side of the templet.