Healthrider AEROBIC RIDER 2 User Manual page 7

,
Depress the two buttons on the sides of the
Handlebar Assembly (6) with your thumb and fore-
finger. Insert the Handlebar Assembly (6) into the
Handlebar Swing Arm (5). Make sure that the but-
tons protrude through one of the two sets of holes
in the Handlebar Swing Arm. The upper holes offer
lower workout resistance; the lower holes offer
higher resistance.
10. Slide the Monitor (35) fully onto the Main Frame (1)
as shown in inset drawing A. Press down on the
Monitor as shown in inset drawing B until it snaps
into place.
11. Remove the battery cover from the Monitor (35).
Insert two new AA batteries into the Monitor. Identify
the negative (-) and positive (+) ends of the batter-
ies. The springs in the battery compartment should
touch the negative ends of the batteries.
10
(_---_ 6
Buttons "7 f=_,_ / JH5°les_
A 35
]
[
B 35
\
11
_ -_.. yRatter,,
_= _= Cover
Batteries
35_
12. Make sure that all parts are properly tightened. To protect the floor or carpet from damage, place a mat
under the AEROBIC RIDER 2.
7