Unpacking And Removing Shipping Bolts - LG WM3370HWA Owner's Manual

NSTALLAT ON NSTRUCT ONS _3
Unpacking and removing shipping bolts 1
When removing the washer from the carton base,
be sure to remove the foam drum support in the
middle of the carton base,
ff you must tay the washer down to remove the
base packaging materials, always lay it carefully on
its side.
Do NOT lay the washer on its #oct or beck.
Ste_ing with the bottom two shipping bolts,
use the wrench (included) to fully loosen eli four
shipping bolts by turning them counterclockwise.
Remove the bolt assemblies by wiggMing them
slightly while pulling them out
Retainer
Foam Tub Carton Base
Support
2 Locate the four hole caps included in the
accessory pack and install them Jn the shipph_g
bolt holes.
................................
/i _ ,_
7 {i
i )
i
r@ NOTE
• Save the bolt assemblies for future u_ To
prevent damage to internal components, DO
NOT transport the washer without reinstaiiing
the shipping bolts.
• Failure to remove shipping bolts and retainers
may cause severe vibration end noise, which
can lead to permanent damage to the washer.
The cord is secured to the back of the washer
with a shipping bolt to help prevent operation
with shipping bolts in place.