Jumper Setting - Acard ANS-9010 Quick Installation Manual

4. Close the upper cover with four screws
I.

Jumper Setting

There are jumpers on the rear site of the ANS-9010. Refer to the following descriptions to set
jumper according to your application.
SATA Power
connector
1. SATA Port0, Port1 working mode
Open: Single mode (default)
Through the SATA port0, we can access the total capacity of DDR2 SDRAM DIMM.
SATA port1 will be disabled.
Short: Dual mode
Each SATA ports can be accessed to one disk with half capacity of total DDR2 SDRAM
DIMM. With this mode enabled, we can double the data transfer rate by configure them
as a RAID0 (stripping) logical disk if the SATA host supports RAID function.
2. SATA port transfer rate
For various application environment, the ANS-9010 was allowed to set the SATA transfer
rate to higher performance one (3.0Gbps) or higher compatibility/stability one(1.5Gbps)
if your SATA controller doesn't work well with ANS-9010.
Open: SATA 3.0Gbps(default)
Short: SATA 1.5Gbps
SATA SATA
Port0
Port1
II.
SATA Port0, Port1 working mode
Reserved
Reserved
SATA transfer rate
Reserved