Table of Contents
Advertisement
AEC-6885 User's Manual
3.1.2 Build Mirror Disk
When changing a mirrored hard drive, you can rebuild the hard drive's data by
"Build Mirror Disk" according to the prompt upon booting. Please see 3.2.2.
NOTICE: The rebuilding time depends on the size of RAID. You can press
Ctrl + S to stop rebuilding.
3.1.3 Quick Erase Disk
This function allows you to quickly erase the data on a selected hard drive. Beware
that the data and the partitions will be completely erased.
3.1.4 RAID Mode Help
This function chiefly tells you that RAID 0+1 must be composed of 4 Master or 4
Slave hard drives. In other words, the hard drives must be set alike.
3.1.5 Card Information
This function indicates the I/O address, ROM address and IRQ number currently
used by AEC-6885.
3.1.6 Set Boot Disk
This function lets you select a hard drive or a pair of hard drives containing OS to
boot. But you need to enter BIOS of the motherboard, then boot "Other Boot De-
vice". If a hard drive has been set as boot disk, there will be a * appearing before its
model number as Figure 3-1 shows.
3.2 Setting of RAID Mode
AEC-6885 supports RAID 0, 1, 0+1 and JBOD modes. The hardware setting re-
lated to each RAID mode is briefly described below. Yet, you are suggested to use
the AEC-6885 RAID Utility to set RAID. Please refer to Chapter 5 and Appendix A.
12
Advertisement
Table of Contents
