Install Memory - Acard ANS-9010 Quick Installation Manual

Install Memory

1. Open the upper cover by unscrewing the four screws
I.
2. Install DDR2 SDRAM DIMM referring to the following figures and notices
I.
3. To prolong battery life, it will not be connected to the control board of the ANS-9010 while
shipping. Please connect it to CN3 to enable the auto-backup function after DDR2 SDRAM DIMM
was properly installed. If you don't need the auto-backup function, please leave it unchanged.
CN3
The DIMM fits into the slot only
one way. Align the notch in the
Open the ejectors
DIMM with the small rib inside
on RAM slots
the slot. With the ejectors open,
push the DIMM until it snaps
into place.
II.
II.
The ejectors close
automatically