Advertisement
Available languages
Available languages
Changing the Water
Filter
.
2.
3.
4.
/
Locate the water filter in the top-right
corner of the
refrigerator
compartment.
Lift open the filter cover door. The filter will be released and
then be ejected as the door is opened.
When the door is completely
open, pull the filter straight
out.
NOTE: There may be some water in the filter. Some spilling
may occur. Use a towel to wipe up any spills.
Take the new filter out of its packaging
and remove the cap.
Be sure the O-rings are still in place after the cap is
removed.
B
° 1
A
B
A. Cap
B. O-rings
5. With the arrow pointing up, align the new filter with the
filter housing and slide it into place. The filter cover door will
automatically
begin to close as the new filter is inserted.
6. Close the filter cover door completely
in order to snap the
filter into place. You may need to press hard.
7. Flush the water system. See "Water
and Ice Dispensers."
sSxs ' , <3e B
•
Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.
•
The quality of your ice will be only as good as the quality of
the water supplied to your ice maker. Avoid connecting the
ice maker to a softened water supply. Water
softener
chemicals (such as salt) can damage
parts of the ice maker
and lead to poor quality ice. If a softened water supply
cannot be avoided, make sure the water softener is
operating
properly and is well maintained.
•
Do not use anything
sharp to break up the ice in the storage
bin. This can cause damage to the ice container and the
dispenser mechanism.
•
Do not store anything
on top of or in the ice maker or
storage bin.
Turning the Ice Maker
On/Off
The On/Off
switch can only be accessed when the ice storage
bin has been removed. The switch is located on the freezer door,
on the left side of the wall that surrounds the ice storage bin.
See the following
section for bin removal instructions.
On
Off
Ice Maker Control
•
To turn on the ice maker, slide the control to the ON (left)
position.
•
To manually turn off the ice maker, slide the control to the
OFF (right) position.
NOTE: The ice maker has an automatic
shutoff to keep the
storage bin from overfilling
during normal operation.
The ice
maker sensors will automatically
stop ice production,
but the
control will remain in the ON (left) position.
Removing and Replacing the Ice Storage Bin
1. Press down the release lever and tilt the bucket outward. Use
both hands to hold the base of the storage bin, then lift it up
and out.
A
2.
A. Re/ease/ever
NOTE: It is not necessary to turn the ice maker control to the
OFF (right) position when removing the storage bin. The
sensor cover ("flipper
door"), located on the right wall of the
freezer door, stops the ice maker from producing ice if the
door is open or the storage bin is removed.
iI
I
A. OnjOlt
switch
B. Sensor cover
Replace the bin by sliding it onto the door, then tilting it
back into an upright position. The release lever will click
when the bin is securely in place.
11
Advertisement
