I.
Place the indicator face-down
on a firm, flat surface.
2. Apply pressure to the bubble on the back of the indicator,
until the bubble pops to activate
the indicator.
3. Slide open the cap on the Produce Preserver housing.
4. Place the indicator
in the top of the housing, facing outward.
5. Slide the cap closed, and check that the indicator
is visible
through the rectangular
hole in the cap.
NOTE: The cap will not easily close if the indicator's
rear
bubble has not been popped.
Replacing the Produce
Preserver (on some models)
The disposable
pouches
should
be replaced
every
6 months,
when the status indicator
has completely
changed
from white
to
red.
To order
replacements,
see "Accessories."
1.
Remove
the old
pouches
from
the Produce
Preserver
housing.
2.
Remove
the old status indicator.
3.
Install
the new pouches
and status indicator
using the
instructions
in the previous
sections.
In order to ensure proper temperatures,
you need to permit air
to flow between the two sections. Cold air enters the bottom of
the freezer section and moves up. It then enters the refrigerator
section through the top vent. (On Style 2 models, this air is also
evenly distributed
throughout the refrigerator
compartment
through six vents on the back wall.) Air then returns to the
freezer as shown.
Style 1
Style 2
/
txxt .............
• . .............
Do not block any of these vents with food such as soda, cereal,
bread, etc. If the vents are blocked, airflow
will be obstructed
and temperature
and moisture problems may occur.
IMPORTANT: Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To avoid odor
transfer and drying out of food, wrap or cover foods tightly.