Depth Adjustment Lever - Bosch 1671B Operating/Safety Instructions Manual

DEPTH ADJUSTMENT
Disconnect battery pack from tool. Loosen the Tighten lever at the depth setting desired.
depth adjustment lever located on the right Check desired depth (Fig. 3).
side of the tool. Hold the foot clown with one Not more than one tooth length of the blade
hand and raise or lower saw by the handle, should extend below the material to be cut, for
minimum splintering (Fig. 4).
U
II=[_EI
CALIBRATED
BRACKET
DEPTH
ADJUSTMENT LEVER
ONETOOTHLENGTHSHOULD
PENETRATE W OODFOR
MINIMUM SPLINTERING
SAFETY SWITCH
The safety switch is designed to prevent
accidental starts. To operate safety switch,
press the release button with your thumb on
either side of handle to disengage the lock,
then pull the trigger (Fig. 5). When the trigger
is released the button will engage the safety
switch automatically, and the trigger will no
longer operate. (See Switch & General Cuts
on page 12.)
I _1[_111,1
SAFETY S WITCH
RELEASE BUTTON
90 ° CUTTING ANGLE CHECK
Disconnect battery pack from tool. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment lever, set to 0 ° on quadrant,
retighten lever and check for 90 ° angle
between the blade and bottom plane of foot
with a square (Fig. 6). Make adjustments by
turning the small alignment screw from bottom
side of foot, if necessary (Fig. 7).
-11-
BEVEL
ADJUSTMENT
FOOT BLADE
ALIGNMENT
SCREW