Control Panel And Features - Kenmore 20112 Series Use & Care Manual

CONTROL PANEL AND FEATURES
Small/ Medium/ Cool/ Warm/ Off/ On/
Petite Moyenne Fr_che T_6de Arr_t Marche
o o • •
Q
Load Size/ Wash Temp/ Fabric Softener/
Tallle de brass6e Temp6rature de lavage Adoaclssant
SE_IES_00 1 _m_ACrlO_ACI_ATOR
S_RmS 300 AOITAT_UR _ _mL_ACTION
Super
Super
Not all features and options are available on all models.
Appearance may vary.
O
LOAD SiZE
Select the setting most suitable for your load. Extra Small
will add a low amount of water for smaller loads and Large
will add the most amount of water for large or bulky loads.
Items need to move freely. Tightly packing the load can lead
to poor cleaning performance, and may increase wrinkling
and tangling.
O
WASH TEMP
Wash Temp senses and maintains uniform water temperatures
by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric and
soils being washed. For best results and following the garment
label instructions, use the warmest wash water safe for your
fabric.
* On some models and cycles, warm and hot water may be
cooler than your previous washer.
* Even in a cold and cool water wash, some warm
water may be added to the washer to maintain
a minimum temperature. All rinses are cold.
FABRIC SOFTENER
This option must be set to "On" if using fabric softener. It
ensures that fabric softener is added at the correct time in the
rinse for even distribution.
if the lid is open when the water stops entering the
machine, the cycle will not begin until the lid has been
closed and the START/PAUSE/Unlock Lid button is pressed.
If the cycle has not been started within 10 minutes of the
water flJJJng the washer, the washer wHJ pump out the
water.
NOTE: Avoid opening lid during sensing phase. The sensing
process wJJl start over when the washer is restarted. The
sensing light may also come on during the Soak and Wash
portions of the cycle. This is normal. To restart the washer
after the Hd has been opened press start,
WASH
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle. The
wash time is determined by the selected soil level.
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the motor
turning on briefly (short hum) to move the basket while
filling. Fabric softener will be added if the "with Softener"
option was selected.
Some cycles use spray rinsing. After draining and spinning
out wash water, the washer will continue to spin and spray
in rinse water for the entire rinse time.
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
See "Cycle Guide" for detailed descriptions of cycles.
START/PAUSE/Unlock Lid button
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes to
unlock the lid. Press and hold for 3 seconds to cancel a cycle.
CYCLE STATUS LIGHTS INDICATOR
S_NSI_G/ WAS_/ _INS_/ _IN/ CO_/ _OC_D/
C2D C2D C2) C2D C2D C2D
The Cycle Status Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that
are different from traditional washers.
SENSING
When the START/PAUSE/Unlock Lid button is pressed,
the washer will fill to the selected water level. If the lid is
closed when the machine is done fllHng the JJd wJJJ Jack
and the machine wJJJ begin operation.
SPiN
The washer spins the load at increasing speeds for
proper water removal, based on the selected cycle
and spin speed.
COMPLETE
Once the cycle is complete, this light will come on. Remove
the load promptly for best results.
LOCKED
To allow for higher spin speeds, the lid will lock and the
Lid Locked light will turn on. When this light is lit, the lid is
locked and cannot be opened. When this light is blinking,
the washer is paused. When this light is off, the lid can be
opened.
If you need to open the lid, press START/
PAUSE/Unlock Lid. The lid will unlock
once the washer movement has stopped.
This may take several minutes if the load
was spinning at high speed. Press START/
PAUSE/Unlock Lid again to resume the
cycle,
I D_:MARRAGE
...... _AUS_ ......
I _u,_
START