Controls - GE AHH24DSH1 Owner's Manual And Installation Instructions

About the controls on the air conditioner
Features and appearance will vary.
Lights
next to the touch pads on the air conditioner controI panel indicate the selected settings.
UO
[] Auto
[] High
[] Med
[] Low
[]cool []On
[] Fan Only [] Off
[] a
Energy Saver
Unit power _41_*
on/off
Mode select
Fan speed _
Delay 1 24hr
Temperature
set/Delay
Timerlncrease
and Decrease=='='='l!_
f
D
|
Q
O
D
Air Conditioner Controls
Remote Control
Controls
4
Power Pad
Turns air conditioner on and off. When turned
on, the display will show the room temperature.
Display
Shows the room temperature or time remaining
on the Delay timer. Shows the Settemperature
while setting the temperature in Coo/or Energy
Savermodes. The Set light will turn on while
setting.
Temp and Delay Increase A/Decrease V
Pads
Use to set temperature or delay time.
Temperature can be set in Cooland Energy
Saving and mode.
Mode Pad
Use to set the air conditioner to Fan Onlyor
Cool, Energy Saver mode,
Fan Speed Pads
In Cool, Energy Saving mode:
Use to set the fan speed to Auto, High, Medor
Lowon the unit.
In Fan Onlymode:
Use to set the fan speed to High, Meal, or Low
on the unit.
Reset Filter
LEDwill turn on when fan has accumluated 250
hours of run time as a reminder to clean filter.
Press Reset Filter to turn off the LED and reset
the accumulated run time.
De/a/Pad
Delay ON--When the air conditioner is off, it can
be set to automatically come on in 1 to 24 hours
at its previous mode and fan settings.
Delay OFF--When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
Press the Delay 1-24hrpad on the unit or the
remote control. Each touch of the Increase A /
Decrease Y pads on the unit or the Increase +
/ Decrease = pads on the remote control will set
the timer in 1-hour intervals.
To review the remaining time on the Delay
1-24hrtimer, press the Delay 1-24hrpad on the
unit or the remote control. Use the Increase A /
Decrease Y pads on the unit or the Increase +
/ Decrease - pads on the remote control to set
a new time if desired.
To cancel the timer, press Decrease • pad on
the unit or the remote control until the set time
is zero. After 3 seconds the light on the Delay
1-24 hour pad goes off.