Advertisement
Available languages
Available languages
Fig,14
DualFlameburner(If equipped)
Remove a lltapesfromburner capBesurethatthedual
flameburner caps arecorrectly placed BEFORE using
yourcooktop.
Note:There arenoburner adjustments necessary onthis
cooktop.
4.Adjustthe "LOW"Settingof Surface Burner V alves
(linearflow)
Test t o verifyif LOW settingshould beadjusted:
a. Push in andturncontrol t o LITE untilburner ignites.
b.
Push in and quickly turn knob to lowest position.
c. If burner goes out, reset control to OFF.
d. Remove the surface burner control knob.
e. Insert a thin-bladed
screwdriver into the hollow valve
stem and engage the slotted screw inside. Flame size
can be increased or decreased with the turn of screw.
Turn counterclockwise
to increase flame size. Turn
clockwise to decrease flame size (Figure 16).
Adjust flame until you can quickly turn knob from
LITE to lowest position without
extinguishing the
flame. Flame should be as small as possible without
extinguishing.
Burner
Burner Simmer
Precision
Flame
Figure
15
Burner
Head
2. Turn on Electrical
Power and Open Main Shutoff
Gas Valve
3. Check the Igniters
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks and range has been connected to
electric power.
a. To check for proper lighting, push in and turn a surface
burner knob to the LITE position.
You will hear the
igniter sparking.
b. The surface burner should ignite when gas is available to
the burner. Purge air from supply lines by leaving knob
in the LITE position until burner ignites. Each burner
should light within four (4) seconds in normal operation
after air has been purged from supply lines.
c. Visually check that burner has a flame, Once the
burner ignites, the control knob should be turned out
of the LITE position.
d. Try each surface control knob separately until all
burner valves have been checked. Each burner
location is equipped with a separate electrode.
Valve
Stem
Figure
16
When All Hookups
are Complete
Make sure all controls are left in the OFF position.
Make sure the flow of combustion and ventilation air to
the cooktop is unobstructed.
Before
You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to the warranty in your Use and Care Guide for
our service phone number and address, Please call or
write if you have inquiries about your product and/or
need to order parts,
9
Advertisement
