Operation Section - Toshiba MML-AP0074NH-E Service Manual

n Operation section
Push each button to select a desired operation.
• The details of the operation needs to be set up once, afterward, the air conditioner can be used by
ON / OFF
pushing
12
2
5
3
1
FAN
button (Air volume select button)
Selects the desired air volume mode.
2
TIMER SET
button (Timer set button)
TIMER SET button is used when the timer is set
up.
3
TEST
button (Check button)
The CHECK button is used for the check operation.
During normal operation, do not use this button.
4
VENT
button (Ventilation button)
Ventilation button is used when a fan which is
sold on the market is connected.
• If "No function
controller when pushing the Ventilation
button, a fan is not connected.
FILTER
5
RESET button (Filter reset button)
Resets (Erases) "
6
SAVE button (Power save operation)
No function
7
SWING/FIX
button (Swing/Wind direction button)
Selects automatic swing or setting the louver
direction.
• This function is not provided to
Concealed Duct Standard Type,
High Static Pressure Type,
Floor Standing Cabinet Type,
Floor Standing Concealed Type or Slim Duct Type.
8
Operation lamp
Lamp is lit during the operation.
Lamp is off when stopped.
Also it flashes when operating the protection
device or abnormal time.
button only.
TEMP.
FILTER
RESET TEST
" is displayed on the remote
FILTER" display.
1 8
ON / OFF
TIMER SET FAN
TIME SAVE
SET CL SWING/FIX UNIT LOUVER
9
ON / OFF
When the button is pushed, the operation
starts, and it stops by pushing the button again.
When the operation has stopped, the operation
lamp and all the displays disappear.
10
MODE
button)
Selects desired operation mode.
11
UNIT LOUVER
Selects a unit number (left) and louver
number (right).
UNIT:
Selects an indoor unit when adjusting wind
VENT
direction when multiple indoor units are
controlled with one remote controller.
LOUVER (4-way Air Discharge Cassette
Type 2H series only):
Selects a louver when setting louver lock or
wind direction adjustment independently.
12
TEMP.
Adjusts the room temperature.
Set the desired set temperature by pushing
TEMP .
OPTION :
Remote controller sensor
Usually the TEMP . sensor of the indoor unit senses
the temperature. The temperature on the surround-
ing of the remote controller can also be sensed.
For details, contact the dealer from which you have
purchased the air conditioner.
• In case that one remote controller controls the
multiple indoor units, the setup operation is
unavailable in group control.
20
9
10
MODE
4
VENT
11
6
7
button
button (Operation mode select
button (Unit/Louver select button)
button (Set up temperature button)
or TEMP . .