Control Application - argon audio iNet3+v2 User Manual

11.2 Setting up the connection to the iNet3+v2
After you download the Wireless Device Remote Control application, you must set up a connection
between the iPhone/Android and the iNet3+v2. To do this, follow these steps:
1. On the iNet3+v2, navigate to Menu > Main menu > System settings > Network > Keep
network connected, and select YES.
The network connection now stays on when the device is in standby mode. This setting is
retained in the device's memory after it is switched off and on again.
2. Set the iPhone/Android to use the same network access point as the iNet3+v2., as follows:
a.
b.
c.
Select Settings > Wi-fi.
Choose the network of the iNet3+v2. from the list.
Default PIN code is 1234
w w w . a r g o n a u d i o . c o m
iNet3+v2
65