argon audio iNet3+v2 User Manual page 56

8.2 Now playing information
While an FM station is playing, the screen shows one of the two following sets data:
•
If RDS information is available, by default the service name (i.e. station name) is
displayed.
You can cycle through further RDS information by pressing Info . Each time you
press Info , another set of information is displayed, cycling through RDS radio text,
RDS programme type, frequency and today's date.
•
If no RDS information is available, the currently tuned frequency is shown.
8.3 Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio
(hiss) from weak stations. To change the scan settings to stop only at stations with good signal
strength, select Menu > Scan setting > Strong stations only? > Yes.
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a
poor signal-to-noise ratio (hiss). To play weak stations in mono, select Menu > Audio setting >
FM weak reception: Listen in mono only > Yes.
w w w . a r g o n a u d i o . c o m
iNet3+v2
56