Advertisement
Door Removal
instructions
Tools Necessary;
Phillios neac
Cover
Screw
Top Hinge
. Cover
Hinge
Screw
/_,op Hinge
J
Hinge
Assembly
Screws/'/"
(
DOOR
REMOVAL
iNSTRUCTiONS:
if it is necessary to move the refrigerator
through narrow doorways,
fo#ow these steps to remove the doors.
iMPORTANT: Before you begin, turn freezer temperature
control to
OFF and remove electrical power cord from wall outlet. Remove any
food from door shelves.
1.
Disconnect electrical supply.
2.
Open both doors, then remove toe grille.
3.
Close doors.
To Remove Refrigerator
Door:
1.
Remove top hinge cover screw on refrigerator door and remove cover.
2.
Trace around hinge with soft lead pencil. This will make it easier to
realign doors when they are replaced.
3.
Remove top hinge and lift refrigerator door off bottom hinge pin. Set
door aside.
4.
Remove bottom hinge, if necessary.
5.
Reverse this procedure to reinstall refrigerator door.
To Remove Freezer Door:
1.
Disconnect water line coming from lower hinge of freezer door at connection
located under front of freezer: grip water tube firmly in one hand. then with
3/8" wrench or fingers, push in on gray collar to release water connector.
2.
Remove top hinge cover screw on freezer door and remove cover.
3.
Disconnect wiring harness connector plug at top hinge: place your thumbs
on fiat sides of each connector and bend both parts back and forth
then with firm grasp, pull both pieces apart.
4.
Trace around hinge with soft lead pencil. This will make it easier to
realign doors when they are replaced.
5.
Remove top hinge, allowingwiring harness to pull through hinge and liftfreezer
door off of bottom hinge pin. Lay door down fiat to avoid kinking water line.
6.
Remove bottom hinge, if necessary.
7.
Reverse this procedure to reinstall freezer door.
When both doors have been reinstalled replace toe grille and plug in electrical
power cord. Turn both temperature controls to center position. Adjust settings
as necessary.
__
_
Water
Line
Hinge /
Tubing
-
\
Assembly
"Screws
6
Advertisement
