Important Instructions - Kenmore 79045319410 Installation Instructions Manual

important Notes to the installer
1. Read all instructions contained in these installation
instructions before installing the cooktop.
2. Remove all packing material before connecting the
electrical supply to the cooktop.
3. Observe all governing codes and ordinances.
4. Be sure to
leave
these instructions with the consumer.
Importanf Note to fhe Consumer
Keep these instructions with your
Use
and Care Guide for
future reference.
iMPORTANT SAFETY
INSTRUCTIONS
° Be sure your cooktop is installed and grounded
properly by a qualified installer or service
technician.
° These cooktops must be electrically grounded in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No.
70mlatest edition in the United States, or with CSA
Standard C22.1, Canadian Electrlcal Code, Part 1, in
Canada.
The electrlcal power to the cooktop must
be shut off while llne connections are being made.
Failure to do so could result in serious injury or death.
An extension cord must not be used with
this appliance. Such use may result in a fire, electrlcal
shock, or other personal injury.
2. The appliance should be connected to the fused
disconnect (or circuit breaker) box through flexible
armored or nonmetallic sheathed cable. The flexible
armored cable extending from this appliance should
be connected directly to the grounded junction box.
The junction box should be located as shown in
Figure 2 with as much slack as possible remaining in
the cable between the box and the appliance, so it
can be moved if servicing is ever necessary.
3. A suitable strain relief must be provided to attach
the flexible armored cable to the junction box.
Observe all governing codes and local ordinances.
Unpacking Instructions
1. Leave corner supports on cooktop until completion
of Electrical Connection.
2. Be sure the bottle of cleaner conditioner packed
in 0the literature bag is left where the user can
find it easily. It is important that the ceramic-glass
smoothtop be pretreated before use. See Ceramic
Glass Cooktop Cleaning and Maintenance section
in the Use and Care Guide.
Provide Electrlcal Connection
Install the junction box under the cabinet and run
120/240 or 120/208 Volt, AC wire from the main
circuit panel. NOTE: DO NOT connect the wire to the
circuit panel at this time. Wait until all wires have been
connected in the junction box.
Electrlcal Requirements
Observe all governing codes and local ordinances.
1. A 3-wire or 4-wire single phase 120/240 or 120/208
Volt, 60 Hz AC only electrical supply is required
on a separate circuit fused on both sides of the
line (a 40A time-delay fuse or circuit breaker is
recommended). DO NOT fuse neutral.
_del and Serial Plate
Figure 3 (Under Cooktop)
//
/
/
/
NOTE: Wire sizes and connections must conform with
the fuse size and rating of the appliance in accordance
with the National Electrical Code ANSIiNFPA No. 70-
latest edition, or with CSA standard C22.1, Canadian
Electrical Code, Part
1,
and local codes and ordinances.
3