Advertisement
Unloading nailer
CAUTION :
Always disconnect the air hose before unloading the nailer.
Pull the pusher lever to the rear. Return the pusher lever
back while keeping the pusher depressed to disengage it
from the strip of nails.
I
I
Depress the nail stopper and remove the strip of nails from
the magazine.
Adjusting depth of nailing
CAUTION:
Pusher lever
Nail stopper
Always lock the trigger and disconnect the hose before adjusting the depth of nailing.
To adjust the depth of nailing, turn the adjuster so that the
arrow above the adjuster will point to the number indicated
on the adjuster. The depth of nailing is the deepest when
the arrow points to the number
1. It
will become shallower
as the arrow points to higher number. The depth can be
changed in approx. 1.0 mm (1132") increments per gradua-
tion. If nails cannot be driven deep enough even when the
arrow points to the number 1, increase the air pressure. If
nails are driven too deep even when the arrow points to the
number 9, decrease the air pressure. Generally speaking,
the tool service life will be longer when the tool is used with
lower air pressure and the adjuster set to a lower number.
Connecting air hose
Lock the trigger. Slip the air socket of the air hose onto the
air fitting on the nailer. Be sure that the air socket locks firmly
into position when installed onto the air fitting. A hose
coupling must be installed on
or
near the tool in such a way
that the pressure reservoir will discharge at the time the air
supply coupling is disconnected.
Air socket
\
Advertisement
