Section 2: Pre-Installation; Mark And Bore Holes On The Door - Westinghouse RTS Series Installation And Operational Manual

Section 2: Pre-installation

Note: If you currently have a Mortise lock, please refer to the conversion kit instructions
that came inside the RTS box. If your door is brand new, please proceed with the
following instructions.

2.1 Mark and bore holes on the door

1) Remove existing handle set.
2) Line up the installation template to the existing hole on the door. Ensure that the
template is square by observing the vertical dotted line which should line up with the
edge of the door. Mark the holes on the door with a permanent marker through the
holes on the template.
Page 7