1:N Mode (User With A Registered Pin Code); 1:1 Mode With An Enrolled Fingerprint - Westinghouse RTS Series Installation And Operational Manual

6.2 1:N Mode (User with a registered PIN Code)

1) Enter the PIN Code on the keypad of the outside unit and press „*‟ button twice.
2) If PIN Code verification was successful, two short beeps will be heard, the RTS will
unlock and remain unlocked for approximately four seconds.
If verification of the registered PIN Code was not successful, three short beeps will be
heard and the RTS will power off.
If a second attempt with a PIN code fails, verify that the PIN Code has been registered
and confirm that the matching mode is set to 1:N.
If one single beep is heard after the PIN code was successfully entered, this indicates
that the user ID is outside of Timed Access settings.

6.3 1:1 Mode with an enrolled fingerprint

1) Enter the User ID on the key-pad
of the outside unit. Then press the #
button. The sensor will illuminate.
Example: User 50 would press
"50#".
2) After the fingerprint sensor
illuminates, rest the enrolled finger
on the sensor window to verify.
Page 20