Brant Radiant Heaters HL2 series User Manual page 10

2.0 Safety • Standards, Certifications and Government Regulations
Chart 2.2 • Standards and Code Installation Guidelines
Building
Location
Guidelines:
High
Altitude
Installation of this tube heater is approved, without modifications, for elevations up to
6,000 feet (1,829 m) MSL (sea level) in the United States. Contact the factory for
installations above these elevations.
The type of gas appearing on the nameplate must be the type of gas used. Installation
must comply with national and local codes and requirements of the local gas company.
Non-
Guidelines:
Standard
BTU Gas
Unless otherwise noted on the rating plate, this infrared heater is designed and orificed to
operate on standard BTU gas. Contact the factory if utilizing non-standard BTU gas.
Chart 2.3 • Standards and Code Installation Guidelines
Building
Aspect
The tube heater must be electrically grounded in accordance with the following codes:
Electrical
United States: Refer to National Electrical Code
Venting
Venting must be installed in accordance with the requirements within this manual and the
following codes:
United States: Refer to NFPA 54/ANSI Z223.1 (latest edition), National Fuel
Applicable authorities governing the manufacturing or installation of this infrared heater include
(but are not limited to) the following organizations:
• NFPA - National Fire Protection Association.
• ANSI Z83.20b - American National Standards Institute.
• NFPA 54/ANSI Z223.1 - National Fuel Gas Code.
• CSA - Canadian Standards Association.
• OSHA - Occupational Safety & Health Administration.
Wiring must conform to the latest edition of National Electrical
®
Code , local ordinances, and any special diagrams furnished.
Canada: Refer to Canadian Electrical Code CSA C22.1 Part 1 (latest edition).
Gas Code.
Canada: Refer to CAN/CGA B149.1 Installation Codes for Gas Burning
Appliances.
• Building Location
Guidelines
• Building Aspect
Codes and Guidelines
®
, ANSI/NFPA 70 (latest edition).
• IAS - International Approval Services.
• AGA - American Gas Association.
• IRSC- Infrared Heater Safety Council.
10
HL2 Series