Unpacking & Installation - Globe GG15G Instruction Manual

TO AVOID SERIOUS PERSONAL INJURY AND PROPERTY DAMAGE:
• ALWAYS install equipment in a work area with adequate light and space.
• ONLY operate on a solid, level, nonskid surface that is nonflammable and away from sinks and water hazards.
• NEVER bypass, alter or modify this equipment in any way from its original condition. Doing so may create
hazards and will void the warranty.
GAS and GAS PRESSURE
These models are designed, built, and sold for commercial use only.
Instructions must be posted in a prominent location. All safety precautions must be taken in the event the user smells
gas. Safety information can be obtained from your local gas supplier.
UNPACKING
Unpack the griddle immediately after receipt. Remove the gas griddle from the crate; remove all packaging on and
surrounding the unit, and be certain to remove protective plastic and residue from all surfaces. Make sure that all
parts, including the L.P. gas conversion kit, are provided.
If the equipment is found to be damaged, save the packaging material and contact the carrier within fifteen (15)
days of delivery. Immediately contact Globe service or your local dealer of the equipment. You have no recourse
for damage after fifteen (15) days of receipt of griddle.
Page 4
Unpacking & Installation
This unit is factory supplied in Natural Gas. This unit can be converted to L.P. gas by a
licensed and certified gas technician. Documentation may be necessary for warranty issues.
Failure to comply with this instruction, will void warranty.
See the included L.P. conversion kit for gas conversion parts and instructions.
Unit installation must conform with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, the
National Gas Installation Code, CSA-B149.1, or the Propane Installation Code, CSA-B149.2
as applicable and in accordance with local codes.
The appliance and it's individual shutoff valve (to be supplied by user) must be disconnected
from the gas supply piping system during any pressure testing of that system at test pressures
in excess of ½ psi (3.45 kPa).