PERIODIC MAINTENANCE AND ADJUSTMENT
6. While supporting the brake caliper
and slightly lifting the wheel, pull
the wheel axle out.
1. Brake caliper
2. Wheel axle
TIP
A rubber mallet may be useful to tap the
7
wheel axle out.
7. Remove the wheel. NOTICE: Do
not apply the brake after the
wheel has been removed to-
gether with the brake disc, oth-
erwise the brake pads will be
forced shut.
[ECA11071]
To install the rear wheel
1. Install the wheel and the brake cal-
iper bracket by inserting the wheel
axle from the right-hand side.
1
TIP
2
●
Make sure that the slot in the brake
caliper bracket is fit over the retain-
er on the swingarm.
●
Make sure that there is enough
space between the brake pads be-
fore installing the wheel.
1
2
1. Brake caliper bracket
2. Slot
3. Retainer
2. Install the drive chain onto the rear
sprocket.
3. Install the axle nut.
7-43
4. Lower the rear wheel so that it is
EAU34434
on the ground, and then put the
sidestand down.
5. Adjust the drive chain slack. (See
page 7-29.)
6. Tighten the axle nut, and then
tighten the locknuts to the speci-
fied torques.
Tightening torques:
Axle nut:
90 Nm (9.0 m·kgf, 65 ft·lbf)
Locknut:
16 Nm (1.6 m·kgf, 12 ft·lbf)
3