Drive Chain Slack - Yamaha FZ6RD(C) Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Drive chain slack

The drive chain slack should be
checked before each ride and adjusted
if necessary.
To check the drive chain slack
1. Place the motorcycle on the side-
stand.
TIP
When checking and adjusting the drive
chain slack, there should be no weight
on the motorcycle.
2. Shift the transmission into the neu-
tral position.
3. Measure the drive chain slack as
7 shown.
Drive chain slack:
45.0–55.0 mm (1.77–2.17 in)
EAU22760
EAU22774
1
1. Drive chain slack
4. If the drive chain slack is incorrect,
adjust it as follows.
To adjust the drive chain slack
Consult a Yamaha dealer before ad-
justing the drive chain slack.
1. Loosen the locknut at each end of
the swingarm, and then loosen the
axle nut.
2. To tighten the drive chain, turn the
drive chain slack adjusting nut at
each end of the swingarm in direc-
tion (a). To loosen the drive chain,
turn the adjusting nut at each end
of the swingarm in direction (b),
and then push the rear wheel for-
ward. NOTICE: Improper drive
TIP
Using the alignment marks on each
drive chain puller, make sure that both
chain pullers are in the same position
for proper wheel alignment.
EAU53910
1. Axle nut
2. Drive chain slack adjusting nut
3. Locknut
7-29
chain slack will overload the en-
gine as well as other vital parts
of the motorcycle and can lead
to chain slippage or breakage.
To prevent this from occurring,
keep the drive chain slack with-
in the specified limits.
[ECA10571]
1
(a)
2
3
(b)