Conair CS50BC Instruction & Styling Manual
Conair CS50BC Instruction & Styling Manual

Conair CS50BC Instruction & Styling Manual

Advertisement

Available languages

Available languages

IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, espe-
cially when children are present, basic
safety precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER
Any appliance is
electrically live even when the switch is off.
To reduce the risk of death by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in, or drop into water or
other liquid.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING
To reduce the risk
of burns, electrocution, fi re, or injury to
persons:
1. This appliance should never be left
unattended when plugged in.
2. This appliance should not be used by, on,
or near children or individuals with certain
disabilities.
3. Use this appliance only for its intended
use as described in this manual. Do not use
attachments not recommended by the
manufacturer.
4. Do not use an extension cord to operate
appliance.
5. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, if it has been dropped or dam-
aged, or dropped into water. Return the
appliance to an authorized service center
for examination and repair.
6. Keep the cord away from heated surfaces.
7. Do not pull, twist, or wrap line cord around
appliance, even during storage.
8. Never place the appliance on a soft surface,
such as a bed or couch, where the air open-
ings may be blocked.
9. Never use while sleeping.
10. Never drop or insert any object into any
opening.
11. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
12. This straightening iron is hot when in
use. Do not let eyes or bare skin touch
heated surfaces.
13. Do not place the heated straightener
directly on any surface or on the appliance
power cord while it is hot or plugged in.
14. Do not attempt to touch the housing of your
appliance near the straightening plates as it is
hot when in use.
15. Do not touch hot surfaces of the appliance.
Use the handles or knobs.
16. Do not use with a voltage converter.
17. Before plugging in, please read the
information about dual voltage in the OPERATING
INSTRUCTIONS section of this booklet.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This straightening iron appliance is intended
for household use. This unit is designed to
operate at 120/240 volts AC. Use on Alternat-
ing Current (50/60 hertz) only.
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature,
this plug will fi t in a polarized outlet only one
way. If the plug does not fi t fully in the out-
let, reverse the plug. If it still does not fi t,
contact a qualifi ed electrician. Do not attempt
to defeat this safety feature.

DUAL VOLTAGE

This straightening iron will automatically
adjust to the proper voltage. Use an adapter
plug with correct confi guration, prior to use
in outlet.

STRAIGHTENING BASICS

1. Plug the straightening iron cord into any
household outlet (120/240V). Slide the tem-
perature setting to ON position. The iron will
heat up very quickly. The power indicator
light will remain on when in operation. To
turn off, slide switch to OFF position (light
will go off). Never leave your straightening
iron on and unattended.
WARNING: The straightening iron's
ceramic-coated plates will get very hot
within a few seconds and should not be
placed in contact with the skin after the
straightening iron has been turned on.
Hair should be clean and completely dried
before using any straightening iron.
2. Start with a hair section that is 2" wide
and no more than 1/2" thick. Open the iron
and place a hair section between the two hot
plates, close to the scalp. Trap hair between
the plates by fi rmly squeezing the handles
together. While maintaining the tension,
slowly pull the unit down along the hair sec-
tion toward the end of hair. For best results,
use a light styling product before blow-dry-
ing hair. At the end of hair section, release
the pressure on the handle and allow the hair
section to slide out. Repeat process on ad-
ditional sections of hair until you achieve the
hair style you desire. It may be necessary
to repeat process on certain areas, depend-
ing on the texture of your hair.
Some experience is necessary when learning
to use this straightening iron. After using iron
several times, you will learn the ideal way to
straighten and style your hair easily.
STYLING WITH THE NEW EASY-GLIDE
CERAMIC-COATED PLATES
The plates of your new straightening iron
have an easy-glide ceramic-coated sur-
face.
Hair glides easily over the surface of the plates
as you're straightening. The ceramic-coated
surface also helps smooth down fl yaways
and frizzies. As you smooth each strand, heat
is evenly distributed so that the style you
create has a salon-perfect, silky smooth,
shining fi nish. Hair slips right off the plates
after it's straightened, and the ceramic
surface is easy to clean.
The ceramic technology is a pleasure to work
with because it makes styling your hair
easier and the results more professional.
GETTING TO KNOW YOUR
STRAIGHTENER
1"
ceramic-coated
plates
Ergonomic
Power
handle
indicator light
On/Off button
Dual voltage
Swivel cord

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CS50BC and is the answer not in the manual?

Questions and answers

Summary of Contents for Conair CS50BC

  • Page 1 OPERATING IMPORTANT SAFETY 4. Do not use an extension cord to operate 2. Start with a hair section that is 2" wide GETTING TO KNOW YOUR appliance. and no more than 1/2" thick. Open the iron STRAIGHTENER INSTRUCTIONS INSTRUCTIONS and place a hair section between the two hot 5.
  • Page 2 Plancha Alaciadora INSTRUCCIONES DE GARANTÍA LIMITADA DE UN AÑO Con Placas Cerámicas Conair reparará o remplazará (a su opción) ADVERTENCIA: MANTENIMIENTO su aparato sin cargo por un período de 12 de 25 mm SI CREE QUE NO meses a partir de la fecha de compra si Su aparato casi no necesita mantenimiento.

Table of Contents