Conair CS70HBC Instruction & Styling Manual

IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially when
children are present, basic safety precautions should
always be followed, including the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER
- Any appliance is electrically
live even when the switch is off. To reduce the
risk of death by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing or in the shower.
3. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
4. Do not place in, or drop into, water or other
liquid.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING
- To reduce the risk of burns,
electrocution, fire, or injury to persons:
1. This appliance should never be left unat-
tended when plugged in.
2. Do not pull, twist, or wrap line cord around
appliance.
3. This appliance should not be used by, on or near
children or individuals with certain disabilities.
4. Use this appliance only for its intended use, as
described in this manual. Do not use attachments
not recommended by the manufacturer.
5. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly or if it has been dropped or damaged,
or dropped into water. Return the appliance
to an authorized service center for examination
and repair.
6. Keep the cord away from heated surfaces.
7. Never use while sleeping.
8. Never drop or insert any object into any open-
ing or hose.
9. Do not use outdoors or operate where aero-
sol (spray) products are being used or where
oxygen is being administered.
10. Unit is hot when in use. Do not let heated
surfaces touch eyes or skin.
11. Do not place the heated unit directly on
any surface or on the appliance cord while
it is hot or plugged in.
12. Never block the air openings of the appliance
or place on a soft surface, such as a bed, couch,
or towel, where the air openings may be blocked.
Keep the air openings free of lint, hair, and
the like.
13. Do not use an extension cord with this
appliance.
14. Do not touch hot surfaces of the appliance.
Use handles or knobs.
15. Before plugging in, read the information
about dual voltage contained in the instruction
section of this manual.
16. Do not attempt to touch the housing of your
appliance near the straightening plates, as it is
hot when in use.
17. Do not use with a voltage converter.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This appliance is intended for household use.
Straightener is designed to operate at 120-240
volts AC. Use on Alternating Current (50/60 hertz)
only. Deep wave styler is designed to operate
at 120 volts AC. Use on Alternating Current (60
hertz) only.
This appliance has a polarized plug (one blade
is wider than the other). As a safety feature,
this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact
a qualified electrician. Do not attempt to defeat
this safety feature.

DUAL VOLTAGE

Straightener will automatically adjust to the
proper voltage. Use an adapter plug with correct
configuration prior to use in outlet.

TO STYLE HAIR

Hair should be clean and completely dry before
using the appliance. Plug this appliance into an
electrical outlet. Turn on unit. The power indicator
light should become illuminated. Allow unit to
heat up for several minutes.
WARNING: This appliance will get very hot
within a few seconds and should not be
placed in contact with the skin after the
styler has been turned on.

STYLING BASICS

Turn on power. This appliance will quickly heat up.
Never leave your appliance on and unattended.
Some experience is necessary when learning to
use this straightening iron and deep waver. After
using iron several times, you will learn the ideal
way to straighten and style your hair easily.

STRAIGHTENING

Start with a hair section that is 2" wide and no
more than 1/2" thick. Open the iron and place
a hair section between the two hot plates, close
to the scalp. Trap hair between the plates by
firmly squeezing the handles together. While
maintaining the tension, slowly pull the unit down
along the hair section toward the end of hair.
For best results, use a light styling lotion before
blow-drying hair. At the end of hair section,
release the pressure on the handle and allow
the hair section to slide out. Repeat process on
additional sections of hair until you achieve the
hair style you desire. It may be necessary to
repeat process on certain areas, depending on
the texture of your hair.

DEEP WAVER

Start with a section of hair that is 2" wide and
place hair in between barrels. Starting at the
scalp, lightly clamp, moving towards the end
of your hair. /hold the waver 5-10 seconds
prior to releasing and sliding down. This
process requires some overlapping to create
the waves in the hair. Repeat the process until
you have achieved the look you desire.

USING QUICk HEAT

Both appliances feature Conair's Quick Heat
technology, which allows the high heat setting
to be used on every hair type from the finest to
the most resistant.
ceramic-coated triple barrel
thumb rest
high/off/low switch
wire stand
MODEL
indicator light
CD369CS
power cord
indicator light
on/off switch
1 in. ceramic-coated plates
cord bushing
MODEL
CS70HBC