Mower Operation - HUSTLER Sport Operator's Manual

Figure 3-6
Inspect the seat belt system (all seat, seat belt parts, seat pan
and seat pan latch) daily prior to mowing for signs of any
damage. These parts should be replaced if any parts indicate
signs of:
• cuts
• fraying
• extreme or unusual wear
• significant discoloration due to UV exposure
• dirt or stiffness
• abrasion to the seat belt webbing
• damage to the buckle, latch plate or hardware.
• any other problem
If the seat belt is to be cleaned, use soap and water. Do not use
carbon tetrachloride, naphtha, or other chemical cleaning
agents, as these will weaken the webbing. For the same reason,
do not bleach or dye the webbing. Replace the seat belt if worn
or damaged.
Possible damage to ROPS
If the unit has rolled over or the ROPS has been in some other
type of accident (such as hitting an overhead object during
transport), the ROPS must be replaced to retain the best
protection.
Following an accident, check the ROPS, the operator's seat,
602902
ROPS
the seat belt, seat belt mountings and seat latch for possible
damage. Before operating the machine, replace all damaged
parts.
IMPORTANT: Do not attempt to weld or straighten the
ROPS.
The ROPS structure's protective capability may be
impaired by structural damage, overturn or altera-
tion. Do not remove or alter any of the ROPS parts. Do
not attempt to weld or straighten ROPS. Failure to adhere
to these instructions could result in severe injury or death.
If the ROPS or cab is replaced, make sure that the proper
hardware is used and the recommended torque values are
applied to the attaching bolts.
ROPS Inspection
Inspect the ROPS after the first 20 hours of operation.
Following the initial inspection, check the ROPS after every 500
hours of operation or every six months, whichever comes first.
1. Check the torque of the ROPS mounting bolts. Tighten
the bolts to the correct torques as shown below if
necessary. Figure 3-7
2. Inspect the operator's seat and the mounting parts for the
seat belt. Tighten the bolts to the correct torque as shown
below if necessary and replace parts that show wear or
damage.
3. Check the seat latch to make sure it is secured and
functioning properly. Adjust or repair it as necessary.
Never operate the mower with the seat latch un-installed
and improperly secured. The seat platform must be
securely latched to prevent seat from moving/tilting in the
event of mower tipping or rollover.
Torque values are given below:
ROPS mounting bolts . . . . . . . . . . . . . . . . . . . . . 55 . . . . 75
Seat belt mounting hardware . . . . . . . . . . . . . . . . 48 . . . . 65

Mower Operation

This mower is equipped with the SmoothTrak™ steering
system. The following provides you with detailed information
on how to operate the mower efficiently.
3-7
WARNING
WARNING
Ft-lbs. N-m
REV H