Front Roller Weight - Jacobsen Eclipse 118 63313 Technical Manual

6 ADJUSTMENTS (ALL UNITS)
6.6

FRONT ROLLER WEIGHT___________________________________________________

The weight on the front roller is adjustable. Adjust the
front roller weight as required to meet your turf needs.
!
CAUTION
To prevent injury or property damage, place mower
on kick stand before removing battery pack.
Full battery packs weigh approximately 55 lbs. Use
proper lifting techniques when moving them.
1. Battery Power Module: To adjust front roller weight,
disconnect power connector (R) and remove battery
pack (S). Loosen hardware (T), place battery pack
back onto mower, take mower off kickstand and slide
battery mounting tray (U) as required.
Gen-Set Power Module: Loosen engine mounting
hardware (V) and slide engine (W) as required
2. To adjust the front roller weight:
a. To increase front roller weight, slide battery tray
(U) or engine (W) towards front of mower.
b. To decrease front roller weight, slide battery tray
(U) or engine (W) towards rear of mower.
c. Use the decal on the power module mount as a
guide for adjusting the front roller weight.
Aligning the oil drain (Gen-Set) or the V-notch in
the battery tray (Battery Tray) with the desired
line on the decal allows for consistent front roller
weight setting.
3. Battery Power Module: When desired weight is
attained, measure distance from edge of power
module mount to tray (U). Remove battery pack (S).
Recheck measured dimension and tighten hardware
(R).
Gen-Set Power Module: Tighten engine mounting
hardware (V).
28
T
Battery Power Module
Gen-Set Power Module
R
S
U
W
V
Figure 6E