Mounting/Dismounting The Belt Clip; Optimization Of Range - Amplicomms V120 User Manual

P G
UTTING THE ERÄTE IN
Operation with rechargeable batteries
1. Open the battery compartment on the rear side of the receiver.
2. Insert the battery pack, and connect it with the socket. The connector can
only be fitted one way.
3. Close the battery compartment again.
The receiver is powered by a a Lithium-ion battery pack of 3.7 V,
1500 mAh. The rechargeable battery pack can be recharged directly in
the receiver when it is inserted in the charging station. The Power LED
lights up red when the receiver is being charged. In the case of a low
battery charge, the Power LED flashes slowly. The battery pack must
then be recharged.

Mounting/dismounting the belt clip

Prize the latch (see figure) with a suitable tool (such as
a small screwdriver) a little bit away from the chassis
and move the belt clip down simultaneously. To attach
the belt clip slide it into the guide towards the top until
it snaps in.

Optimization of range

Baby unit and parent unit come with
fold-out antennas. If necessary, opti-
mum range can be achieved if both
the Baby unit and Parent unit anten-
nas are extended vertically.
30
B U
ETRIEB NEHMEN NITS INTO
Helpline UK 0844 800 6503
(See page 42 for costs and hours of operation)
O
PERATION