Adjusting Procedure - ViewSonic VX500PLUS-1 Service Manual

15” color tft lcd display

Hide thumbs

Table Of Contents

Table of Contents

Instrument alignment

1. Preparation of manual alignment

2. Color temperature alignment

3. Factory preset setting

4. Download serial number procedure

1. Preparation of manual alignment

1.1 The alignment procedure is performed after unit been completely assembled and before set

inspection.

1.2 Before set been aligned, set should be burned-in for over 30min.

1.3 Measuring equipment used

Pre-programmed chroma 2226 or equivalent.

Colorimeter Minolta CA110 or equivalent.

1.4 Method to enter/exit factory mode

1.4.1 Press "VOL+" and "1" and "Down" Key simultaneously 3 times when display is powered on

with an image.

1.4.2 To ensure the monitor is under factory mode, check following OSD image display.

Otherwise, follow the procedure. Described in session 1.4.1 to enter the factory mode again.

1.4.3 Under factory mode, press " 1" Key. The monitor will exit factory mode and under ordinary

ViewSonic Corporation