Silvercrest SFB 10.1 B2 Operating Manual page 18

1. Hold the S button
3 seconds. The notice „LANGUAGE SETUP" appears.
2. With the
confirm with the OK button
3. With the
and confirm with the OK button
4. The LCD display
button
5. Now press the device button
controlled by the global volume control.
6. If the specified device is equipped with a volume control,
"SUCCESS" will be displayed briefly and the menu will
close. From now on the volume control functions on the
device just specified.
7. If this device is not equipped with its own volume control
the URC will not allow this selection and shows "VOLUME
ERROR". Even then the menu will close. The volume con-
trol will then continue to function on the former device.
You can also deactivate the global volume control for specific
devices.
1. For this select in the menu "VOL/MUTE SETUP" with the
or
confirm with the OK button
pears „MODE VOL MODE".
2. Now press the device button
be excluded from the global volume control. The LCD
display
control is deactivated if the URC is working in the opera-
tional mode of one of the selected devices.
You can again override the settings in the "VOL/MUTE
SETUP" menu.
1. For this select in the menu "VOL/MUTE CONF" with the
or
confirm with the OK button
2. The LCD display
to a confirmation which is done by pressing the OK
button
the setting, the displayed "SUCCESS" then confirms the
deletion of the device assignment to global volume con-
trol. Otherwise you press the EXIT button
deletion.
or button
or button
shows "ALL VOL SET". Press the OK
, the display changes to „ALL VOL MODE".
button the function "MODE VOL SET" and
shows „SUCCESS" and the global volume
button the function "VOL/MUTE RESET" and
prompts you, with CONFIRM RESET,
. Press the OK button
down for a little longer than
select "SYSTEM SETUP" and
.
select "VOL/MUTE SETUP"
for the device that is to be
. In the LCD display
for the device that is to
.
.
if you want to delete
to abort the
ap-