Before First Use - Zanussi ZDV12002FA User Manual

German degrees French degrees
(°dH)
11 - 14
4 - 10
<4
1) Factory setting
2) Do not use salt at this level.
ACTIVATING THE ACOUSTIC SIGNAL FOR THE END OF PROGRAMME
By default this acoustic signal is deactivated but it is possible to activate it.
1. While the appliance is in user mode, within about 5 seconds press programme button: the indicator
is on and the indicator
2. Wait until the indicator
3. Press programme button to change the setting. The indicator
4. Press on/off button to confirm the setting.

BEFORE FIRST USE

1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance.
8
mmol/l
(°fH)
19 - 25
7 - 18
<7
starts to flash.
goes off. The indicator
Clarke degrees
1.9 - 2.5 13 - 17
0.7 - 1.8
<0.7
is off. The acoustic signal is off.
is on. The acoustic signal is on.
Do not use detergent and do not load the
baskets.
When you start a programme, the appliance can
take up to 5 minutes to recharge the resin in the
water softener. It seems that the appliance is not
working. The washing phase starts only after this
procedure is completed. The procedure will be
repeated periodically.
Water softener
level
5 - 12
< 5
3
2
2)
1