Getting Started - Reebok TITANIUM CONSOLE TC1.0 User Manual

TC1.0/TX1.0
CONSOLE USER GUIDE

GeTTinG STarTeD

• When the power is switched on the computer will beep and the full screen display will be shown
for 2 seconds (Figure 1). The computer will then enter the user profile setting mode (Figure 2).
• If no use is detected for a period of 4 minutes the computer will switch off. Begin to pedal
to turn back on.
FIGURE 1
FIGURE 2
• You can simply press the QUICK START button to start the workout immediately without
setting the user profiles or pre-set programs. The resistance can be adjusted by rotating
the i-Drive at any time.
4

UK
USer proFiLe SeTTinG
From power on screen, rotate the i-Drive knob to select the user
(U1, U2, U3, U4, U5) press to confirm selection.
GenDer
SEX will be displayed on right side of screen. Select the
gender by rotating the i-Drive knob, "F" = female, "M" = male.
Press the i-Drive to confirm.
aGe
AGE will be displayed on right side of screen. Select by
rotating the i-Drive knob. Press the i-Drive to confirm.
HeiGHT
H.t will be displayed on right side of screen. Select by
rotating the i-Drive knob. Press the i-Drive to confirm.
WeiGHT
W.t will be displayed on right side of screen.
Select the weight by rotating the i-Drive knob.
Press the i-Drive to confirm.
The console will enter the programs selection mode.
To change the user code, press STOP, then press and
hold RESET button for 3 seconds to go back to power
on screen.
AGE
5
reebokfitnessequipment.com