Toyota 2007 Camry Owner's Manual page 337

WWW.MANUALS.WS
(b) Emergency start (vehicles
with smart key system)
When the engine does not start, the fol-
lowing procedure can be used to start the
engine if the vehicle's starting system and
"ENGINE START STOP" switch function
normally.
1. Put the transmission in "P".
2. Set the ignition switch to ACC by push-
ing the "ENGINE START STOP" switch
once.
3. Push and hold the "ENGINE START
STOP" switch for about 15 seconds
while depressing the brake pedal firmly.
Even if the engine can be started using
the above procedure, the system may be
malfunctioning. Have the vehicle checked
by your Toyota dealer.
If the engine cannot be started using the
above procedure, immediately contact your
Toyota dealer.
WWW.MANUALS.WS
'07Camry_U (L/O 0608)
CAUTION
Do not place any objects close to the
"ENGINE START STOP" switch. If the
object pushes on the switch, an unex-
pected engine start may result.
(c) Starting a flooded engine
If the engine will not start, your engine
may be flooded because of repeated
cranking.
With key cylinder−type ignition switch—If
this happens, turn the key to "START"
with the accelerator pedal fully depressed.
Keep the key and accelerator pedal in
these positions for 15 seconds and re-
lease them. Then try starting the engine
with your foot off the accelerator pedal.
With smart key system—If this happens,
press the "ENGINE START STOP" switch
(engine switch) with the brake pedal and
the accelerator pedal fully depressed, and
hold the "ENGINE START STOP" switch
for about 30 seconds. Then the cranking
hold function stops cranking automatically,
and you can try starting the engine with
your foot off the accelerator pedal.
If the engine does not start, wait a few
minutes and try again.
If the engine still will not start, it needs
adjustment or repair. Call a Toyota dealer
or qualified repair shop for assistance.
2007MY CAMRY from Oct. '06 Prod. (OM33748U)
337