Toyota 2007 Camry Owner's Manual page 162

Hide thumbs Also See for 2007 Camry:
Table of Contents

Advertisement

WWW.MANUALS.WS
(b) Normal driving
1. Start the engine as instructed in "How
to start the engine" on page 316 in
Section 3. The transmission must be in
"P" or "N".
2. With your foot holding down the brake
pedal, shift the selector lever to "D".
When the lever is in the "D" position, the
automatic transmission system will select
the most suitable gear for running condi-
tions such as normal cruising, hill climb-
ing, hard towing, etc.
Always use the "D" position for better fuel
economy and quieter driving. If the engine
coolant temperature is low, the transmis-
sion will not shift into overdrive gear even
in the "D" position.
CAUTION
Never put your foot on the accelera-
tor pedal while shifting.
3. Release the parking brake and brake
pedal. Depress the accelerator pedal
slowly for smooth starting.
162
WWW.MANUALS.WS
'07Camry_U (L/O 0608)
(c) Using engine braking
To use engine braking, you can downshift
the transmission as follows:
R
Shift into the "4" position. The trans-
mission will downshift to fourth gear
and engine braking will be enabled.
R
Shift into the "3" position. The trans-
mission will downshift to third gear
when the vehicle speed drops down to
or lower than 141 km/h (76 mph), and
stronger engine braking will be en-
abled.
R
Shift into the "2" position. The trans-
mission will downshift to second gear
when the vehicle speed drops down to
or lower than 89 km/h (48 mph), and
stronger engine braking will be en-
abled.
R
Shift into the "L" position. The trans-
mission will downshift
to first gear
when the vehicle speed drops down to
or lower than 40 km/h (21 mph), and
maximum engine braking will be en-
abled.
Vehicles with cruise control—When the
cruise control is being used, even if you
downshift from "D" to "4", engine braking
will not be enabled because the cruise
control is not cancelled.
For ways to decrease the vehicle speed,
see "Cruise control" on page 181 in this
Section.
CAUTION
Be careful when downshifting on a
slippery
surface.
Abrupt
could cause the vehicle to skid or
spin.
(d) Using "3", "2" and "L" positions
The "3", "2" and "L" positions are used for
strong engine braking as described pre-
viously.
With the selector lever in "3", "2" or "L",
you can start the vehicle in motion as
with the lever in "D".
With the selector lever in "3" or "2", the
vehicle will start in first gear and automat-
ically shift to third gear or second gear.
With the selector lever in "L", the trans-
mission is engaged in first gear.
2007MY CAMRY from Oct. '06 Prod. (OM33748U)
shifting

Advertisement

Table of Contents
loading

Table of Contents