4. Activate Your Wireless Account ....2 5. Provision your PT300D ....3 6.
Page 2
PT300D Command Module. 3 . Charge up your Sensor Pack a) In order to use your PT300D, as well as to provision it, you’ll need to have your Sensor Pack fully charged.
Page 3
(indicating success). a) Once your airtime account is activated and your Sensor Pack fully charged, c) Remove Command Module from Sensor plug the pack into the PT300D Pack Command Module. To remove the PT300D Command Module, squeeze the two tabs on the side of the device, then pull the module out of the Sensor Pack.
Page 4
PT300D QuickStart Guide 7 . Configure your Trackers For information on how to use your PT300D trackers within Findum, please refer to the detailed Findum Help Guide. Once you are logged into Findum, the guide is accessible by clicking the Help link in the upper left hand corner of any Findum page.
Need help?
Do you have a question about the PT300D and is the answer not in the manual?
Questions and answers