Makita 9566CV 004051 Instruction Manual page 7

2
1. Speed adjusting dial
Number RPM (/min)
1
|
2
|
3
|
4
|
5
ASSEMBLY
1. Wheel guard for cut-off wheel
2. Bearing box
3. Screw
Speed adjusting dial
001046
The rotating speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 5.
Higher speed is obtained when the dial is turned in the direc-
tion of number 5. And lower speed is obtained when it is
turned in the direction of number 1.
1
Refer to the table for the relationship between the number
settings on the dial and the approximate rotating speed.
CAUTION:
• If the tool is operated continuously at low speeds, the
4,000
|
motor will get overloaded and heated up.
5,000
|
• The speed adjusting dial can be turned only as far as 5
6,500
and back to 1. Do not force it past 5 or 1, or the speed
|
8,000
adjusting function may no longer work.
|
9,000
The tools equipped with electronic function are easy to oper-
ate because of the following features.
• Electronic constant speed control
Possible to get fine finish, because the rotating speed is
kept constantly even under the loaded condition.
• Soft start feature
Soft start because of suppressed starting shock.
• Overload protector
When the tool would be employed over the admissible
load, it will stop automatically to protect the motor and
wheel. When the load will come to the admissible level
again, the tool can be started automatically.
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing the wheel guard
004200
1
Mount the wheel guard with the tab on the wheel guard band
aligned with the notch on the bearing box. Then rotate the
2
wheel guard counterclockwise. Be sure to tighten the screws
3
securely.
7