Replacing And Installing Clock Backup Batteries - iHome iBN43 Instruction Manual

Replacing and Installing Clock Backup Batteries

Note: 2 AA batteries are included in the unit. Please pull out the battery pull tab before you use the unit.
This model is equipped with a battery backup circuit that will maintain the time and alarm time settings in
the event of a temporary power interruption. The battery backup circuit will also operate the buzzer alarm
to wake you up at the selected wake up time even if the power is out. The battery backup circuit requires
two AA batteries, included.
When the backup batteries are getting weak the Low Backup Battery Indicator will begin flashing in the
display. When you see this flashing indicator you should replace the backup batteries as soon as possible.
Follow steps 1 - 3 below to install the replacement batteries.
To replace the backup batteries:
IMPORTANT: When replacing the backup batteries be sure to have the unit
connected to the AC outlet to maintain all of your settings, otherwise it will be
necessary to reset the time and alarm time after the battery is replaced.
1. Remove the battery cover located on the bottom of the unit and remove the
exhausted AA batteries.
2. Insert 2 fresh AA batteries in the backup battery compartment with the "+/–"
ends facing as shown.
3. Replace the battery compartment cover. Confirm that the backup battery
indicator is not flashing in the display.
Note: Make sure you dispose of all batteries properly (see your local regulations).
For models that require more than one battery
• Do not mix with used or other battery types/brands
• Replace all batteries at the same time
• Do not open batteries
• Do not dispose of in fire
Using the
• Do not heat above 75ºC (167ºF)
• Do not expose contents to water
• Do not charge or recharge
• Do not install backwards
15
iBN43
Replacing Backup Batteries