Radionics D9024 Operator's Manual

D9024 and D10024
Operator's Manual

Notice

The material and instructions covered in this manual have been carefully checked for accuracy and are
presumed to be reliable. However, the manufacturer assumes no responsibility for inaccuracies and
reserves the right to modify and revise this document without notice.
These instructions are the Operator's Manual at the Display, Control, and Limited Programming Levels of
operation. See the Installation Manual for information on installation and powering the D9024 and
D10024 Fire Alarm Control Panels (FACP). See the Programmer's Guide for information on
programming and Level Three operation of the system

Warnings and Cautions

WARNING is used in these instructions to indicate procedures to follow to avoid injury.
CAUTION is used in these instructions to indicate procedures to follow to avoid damage to
equipment.

FCC Notices

Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a commercial installation. This equipment generates, uses and can radiate radio
frequency energy, and, if not installed in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment on and off, the user is encouraged to try to correct the
interference by one or more of the following measures:
1) Reorient or relocate the receiving antenna
2) Increase the separation between the equipment and the receiver
3) Connect the equipment in to an outlet on a circuit different from that to which the receiver is
connected.
4) Consult the dealer or an experienced radio/TV technician for help.

UL/NFPA Notices

•
UL listed for NFPA 72, Local.
All references to NFPA and related requirements are based upon compliance with the 1993 edition of
NFPA 72, National Fire Alarm Code. Since installation specifications are nearly always based upon a specific
edition of a standard that has been legally adopted by the Authority Having Jurisdiction (AHJ), earlier editions
of NFPA standards will generally apply. Consult with the appropriate AHJ for confirmation.
©1997 Radionics
™The Radionics logo is a registered trademark of Radionics,
1800 Abbott Street, Salinas, CA 93901, USA
Analog Fire Alarm Control Panels
All rights reserved
74-07661-000-B 01/97
D9024/D10024 Operation
Page 1 of 13