Table of Contents
Advertisement
© 1997 Radionics, Inc., Salinas, CA, U.S.A. All rights reserved.
™ The Radionics logo is a registered trademark of Radionics, Inc., Salinas CA, U.S.A.
Reference Guide
D7024 Control/Communicator
Radionics, Inc., 1800 Abbott Street
Salinas, CA 93901, U.S.A.
Customer Service: (800) 538-5807
for the
6/20/97
D7024 Reference Guide P/N 31499B
Advertisement
Table of Contents
Related Manuals for Radionics D7024
Summary of Contents for Radionics D7024
- Page 1 Radionics, Inc., 1800 Abbott Street Salinas, CA 93901, U.S.A. Customer Service: (800) 538-5807 © 1997 Radionics, Inc., Salinas, CA, U.S.A. All rights reserved. ™ The Radionics logo is a registered trademark of Radionics, Inc., Salinas CA, U.S.A. D7024 Reference Guide P/N 31499B...
-
Page 2: Table Of Contents
8.0 Menu Tree (CMND#, TEST, HISTORY, Notice DISABLE, DRILL) 1.0 Overview 9.0 Installation Guide for U.L. Listed Systems 1.1 System Overview 1.2 Specifications 9.1 D7024 U.L. Listings 1.2.1 Enclosure Housing 9.2 Installation Considerations 1.2.2 Temperature 9.3 Programming the D7024 1.2.3 Power 9.4 Reversing Modules 1.2.4 Outputs... -
Page 3: Notices
If they do, you will be notified in advance to give you an opportunity to maintain uninterrupted telephone service. D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 3... -
Page 4: Overview
• Remote Relay Module (D7035): The D7035 is an Octal Relay Module that provides 8 Form “C” 1.2.1 Enclosure Housing relay outputs. It connects to the D7024 via the option bus. The outputs are fully programmable, The standard enclosure is manufactured from 18 exactly as the local relays are programmed. -
Page 5: Keypads
1.2.10 Backup Battery Calculation • The following table is used to calculate the standby battery capacity required by NFPA when using the D7024: 1.2.11 Standby Current Load • Battery AH - (20% Storage + 0.375 AH's Alarm) •... -
Page 6: Enclosure Installation
2.0 Enclosure Installation The D7024 control/communicator and the enclosure are 2.2 Install the Control/Communicator shipped together. The control, however, still needs to be CAUTION: The control is static sensitive. Make sure installed into the enclosre. Hardware for mounting the you touch ground before handling the enclosure to a wall, and the control to the enclosure is control. -
Page 7: Control Terminal Wiring
3.0 Control Terminal Wiring D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 7... -
Page 8: System Worksheet
Telephone Jack________________________________________________________________________________________ Telephone On Same Line as Panel_________________________________________________________________________ Earth Ground Connection________________________________________________________________________________ Notification Appliances__________________________________________________________________________________ Initiating Devices______________________________________________________________________________________ Misce llane ous Note s ____________________________________________________________________________ ____________________________________________________________________________ ____________________________________________________________________________ ____________________________________________________________________________ ____________________________________________________________________________ ____________________________________________________________________________ ____________________________________________________________________________ ____________________________________________________________________________ ____________________________________________________________________________ ____________________________________________________________________________ Page 8 Copyright © 1997 Radionics, Inc. D7024 Reference Guide... - Page 9 User 01 User 02 User 03 User 04 User 05 User 06 User 07 User 08 User 09 User 10 User 11 User 12 User 13 User 14 User 15 D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 9...
- Page 10 Smoke Detector Hallway Fire, Alarm on Short, Latching, Verification De vice (s) Location(s) Type Point 1 Point 2 Point 3 Point 4 Point 5 Point 6 Point 7 Point 8 Page 10 Copyright © 1997 Radionics, Inc. D7024 Reference Guide...
-
Page 11: Operating Guide
• Backlight Control - The display backlight intensity can be adjusted using the [3] and [6] keys along with the [*] key. - Hold the [*] key while pressing the [3] key to increase the brightness or the [6] key to decrease the brightness. D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 11... -
Page 12: System Operation
5.3 System Operation 5.3.1 Modes of System Operation There are three modes of system operation for the D7024 control/communicator: • Normal Operation: When the system is operating normally, it displays “SYSTEM NORMAL” on the top line of the display, the Power LED is on steady, and no other LEDs are lit. If the system is programmed to require a PIN, the second line of the LCD screen will display “ENTER PIN:”, otherwise the control... -
Page 13: Fire Silence/Reset
When considering detectors for residential applications, refer to NFPA Standard 72, “The National Fire Alarm Code.” This standard is available at a nominal cost from: The National Fire Protection Association, Batterymarch Park, Quincy, MA 02269. D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 13... -
Page 14: If Installed In Family Residences
• Place the top edge of wall mounted detectors between 4 and 12 inches (10 and 30 cm) from the ceiling. For exact mounting information, refer to the instructions provided with the smoke detectors. Page 14 Copyright © 1997 Radionics, Inc. D7024 Reference Guide... -
Page 15: Personal Identification Numbers
NOTE: This test is available only if your system transmits alarms and system information to a monitoring service, and has been programmed by the security installing company to permit communicator tests. D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 15... -
Page 16: Remote Program Dial-Out And Answer
Trouble LED will flash. In addition to allowing a connection for remote programming, this will allow on-site PC downloading. If the panel is already using the phone line for a report communication, it will sound the three beep error tone. Page 16 Copyright © 1997 Radionics, Inc. D7024 Reference Guide... -
Page 17: How To Program
At any time during your viewing of the history, you can press the 7 or 9 keys to move forward or backward through the list of system events. D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 17... -
Page 18: Alpha Programming
#/CMD programming menu returns to programming menu without */CLEAR entering changes SILENCE moves cursor one space right DISABLE moves cursor one space left Page 18 Copyright © 1997 Radionics, Inc. D7024 Reference Guide... -
Page 19: Programming Menu Tree (Prog/0)
YES (1) NO (0) operation to clear alarms and reset smoke detectors. 6- SILENCE: When activated, point initiates a panel silence 7- (reserved) operation to turn off sounders. 7- (reserved) 8- (reserved) D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 19... - Page 20 Zone 56 Pre-signal or Alarm Investigation Delay Active corner of this page. YES (1) NO (0) Zone 55 Releasing Cycle Started Zone 54 Activates for Ground Start Zone 53 General Fire Page 20 Copyright © 1997 Radionics, Inc. D7024 Reference Guide...
-
Page 21: Menu Tree (Cmnd#, Test, History, Disable, Drill)
1 - 8. 1- ON, 0- OFF 3- REMOTE 2 SAME 1 - 8 OPTIONS AS REMOTE 1. 7- TEST INPUTS POINT NUMBER (1 - 4/8) 1- PREV INPUT 2- NEXT INPUT D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 21... -
Page 22: Installation Guide For U.l. Listed Systems
A compatible Listed 4-wire The D7024 is U.L. Listed for the following: detector is the Radionics, Inc. D285 in a D292 or • Commercial Fire Alarm (Type Service: Local, D293 Series base. A compatible Listed EOL relay is Central Station, and Remote Station;... -
Page 23: Appendix A: Abbreviations On Panel Display
INIT = Initialize KPAD, KYPAD, KYPD = Keypad LNAC = Local NAC LOC = Local MACH = Answering Machine MONI, MON = Monitor NAC = Notification Appliance Circuit NMBR, NUM = Number D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 23... -
Page 24: Appendix B: Defaults For Prog/0
2- SETUP KEYPAD: 0 8- LOCAL ONLY: NO 5- PIN REQUIRED 9- CONFIGURE: Fire ( Point 4 = Waterflow ) 1- LOCAL: NO 2- REMOTE: YES 6- REPORT/MONI.: YES 7- (reserved) Page 24 Copyright © 1997 Radionics, Inc. D7024 Reference Guide... - Page 25 Relay7/Zone A = 7 4- FIRE DRILL: FD Relay8/Zone A = 8 5- FIR DRIL RSTR: ED 4- SIA SIL RPT 1- LEFT BYTE: 42 ‘K’ 2- RIGHT BYTE: 42 ‘B’ D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 25...
-
Page 26: Index
Escape Plan 14 Point/Zone Mapping 12 Power 4 Power, Auxiliary 4 Fire Safety 13 Power, Input 4 Fire Silence/Reset 13 PROG/0 17, 19, 20 Format Programming 18 Programming Menu Tree 19, 20 Page 26 Copyright © 1997 Radionics, Inc. D7024 Reference Guide... - Page 27 TEST 17, 21 Testing 15 Time, Response 4 Trouble Operation 12 Trouble, System 13 U.L. 22 User Codes 4 User Number 15 Users 5 Volume Control 11 Walk test 15 Zones 12 D7024 Reference Guide Copyright © 1997 Radionics, Inc. Page 27...
- Page 28 ™The Radionics logo is a registered trademark of Radionics, Inc., Salinas, CA, U.S.A. ©1997 Radionics, Inc., Salinas, CA, U.S.A. All rights reserved Radionics, Inc., 1800 Abbott Street Salinas, California 93901 Customer Service: (800) 538-5807...